Setup for Bioresonance Therapy

This post is also available in: Chinese (Traditional) Croatian French German Greek Hungarian Indonesian Italian Portuguese (Brazil) Romanian Spanish

–         Therapy can be applied while the client is either sitting or lying down

–         The Mode is set to Homeopathic to feed-back client frequencies in sync with his own frequencies or to Allopathic to re-introduce the client’s own frequencies – mirror image- with a 180 Degree phase difference. For now we are not able to provide general rules on which setting to use but is seems indicated in all more paralytic, passive and tired symptomatologies to use the activating Allopathic mode and in all situations of Inflammation, nervousness, high pressure indications to use the calming and relaxing homeopathic mode  

–         The Sensing electrodes can be applied anywhere on the clients body, generally it is most simple to use the two electrodes of the foot-electrode

–         The applicator electrode should generally be connected to Ch2 of the Health Integrator as this channels  can be fine-tuned for amplification and mixing with an external source with the middle knob, whereas Ch1 of the Health Integrator always exclusively monitors the client Eigen-Frequencies

–         Instead or additionally to the Electric applicator also Magnetic, LED pad/ glasses, or Laser applicator can be used, however it is recommended to keep it simple and not overload the body with too many different stimuli and to use 2 applicators at most for every session

–         The Amplitude that is being supplied to a given applicator is shown on the 2 bars of the Health Integrator labeled 1-14 Volt, it is recommended particularly with electric applicators to start low and increase the volume as the client feels best

–         Amplification is first set with the slider switch under the left knob by moving from 1 to 10 to 100 while having the knob in approximately 3 position, when the  green lights of the bars next to the knob turn on – fine tuning is possible with the knob such that the orange top LED not or only barely turns on

–         Then with the middle knob the desired voltage on Ch2 of the Health Integrator is set as found most agreeable to the client