This post is also available in: Chinese (Traditional) Croatian French German Greek Hungarian Indonesian Italian Portuguese (Brazil) Romanian Spanish
1.1. Setup for Bioresonance Therapy
the following is one chapter from our user – manual – with latest additions
2.4.1 standard setup
– Therapy can be applied while the client is either sitting or lying down
– The Mode is set to Homeopathic to feed-back client frequencies in sync with his own frequencies or Allopathic mode to re-introduce the client’s own frequencies mirror image with a 180 Degree phase difference. For now we are not able to provide general rules on which setting to use but is seems indicated in all more paralytic, passive and tired symptomatologies to use the activating Allopathic mode and in all situations of Inflammation, nervousness, high pressure indications to use the calming and relaxing homeopathic mode
– The Sensing electrodes can be applied anywhere on the clients body, generally it is most simple to use the two electrodes of the foot-electrode
– The applicator electrode should generally be connected to Ch2 of the Health Integrator as this channels can be fine-tuned for amplification and mixing with an external source with the middle knob, whereas Ch1 of the Health Integrator always exclusively monitors the client Eigen-Frequencies
– Instead or additionally to the Electric applicator also Magnetic, LED pad/ glasses, or Laser applicator can be used, however it is recommended to keep it simple and not overload the body with too many different stimuli and to use 2 applicators at most for every session
– The Amplitude that is being supplied to a given applicator is shown on the 2 bars of the Health Integrator labeled 1-14 Volt, it is recommended particularly with electric applicators to start low and increase the volume as the client feels best
– Amplification is first set with the slider switch under the left knob by moving from 1 to 10 to 100 while having the knob in approximately 3 position, when the green lights of the bars next to the knob turn on – fine tuning is possible with the knob such that the orange top LED not or only barely turns on
– Then with the middle knob the desired voltage on Ch2 of the Health Integrator is set as found most agreeable to the client
2.4.2 Biofield feedback setup
ANOTHER WAY TO CONNECT THE BIORESONANCE-LaesEr based on the experience with hundreds of clients at Marco Paulo’s Quadtrinity clinic Portugal
This is the result of a lot of experimenting with the standard set-up explained previously. At Quadtrinity clinic it was found that this set-up is more effective and even longer therapies and higher therapy signal amplitudes have always been tolerated well. Kiran could initially not believe that this scheme could work so, when he was in Portugal he tested himself
… and yes it works very well I cannot remember a session that was so centering – apparently because it uses the cannel that extracts particularly the Biofield frequencies, so it feeds back and amplifies the frequency field that is measurable close to the body and that has been called Aura in traditional scriptures – you feel as if you are coming home to your own bubble
AND …. Please take this as a great example to understand – there is much to learn with the LaesEr – it is a cutting edge technology and we know only few of its new possibilities and how to realize them – so experiment , and share with all of us your results
2.4.3 dual handelectrode with with body-signal application
|
IF you want to use the handelectrodes in the way you otherwise us the flexible mats – which means to tap into the electric body-signal that is conventionally measurable with ECG and EEG equipment please be aware that the connection have to be done as follows : |
 |
